Skip to content

Network Discovery ​

WebWorkstation

Network Discovery gives ZynoRMM technicians a recent view of managed wired networks and the devices observed on them. It is designed for troubleshooting and endpoint location, not as a permanent asset register or a vulnerability report.

Manager Access required

All authorized technicians can review discovery information. Only ZynoRMM managers can change its policy.

Enable or review discovery ​

  1. Open ZynoRMM > Settings > Network Discovery.
  2. Review the organization-wide policy. MSP users can select a managed organization to review its separate policy.
  3. Choose Enabled to turn on background discovery, Disabled to turn it off, or Inherited for an organization to follow the organization-wide setting.
  4. When changing an enabled policy, review the scan schedule and TCP port list, then select Save.

Discovery is off until a manager enables it. An organization can inherit the organization-wide policy or use its own enabled/disabled setting.

Review networks and devices ​

Open ZynoRMM > Networks. The network list shows each discovered network, its gateway, discovery state, and first/last-seen times. Select a network to review the attached managed endpoints and recent devices, including their observed address, names, vendor, configured open TCP ports, and last observation.

A network appears when at least one managed endpoint identifies it. That endpoint can be offline; the list reflects its latest detected network. Networks with no remaining managed endpoints are hidden and cannot be scanned. Moving endpoints between organizations immediately updates their network grouping, including moves to or from Unassigned.

Scanning requires a connected, included endpoint on a verified physical Ethernet interface with sufficient headroom and suitable power. It never scans through Wi-Fi or cellular interfaces. Background discovery additionally requires two online agents agreeing on the network and gateway. To request an immediate scan using one suitable endpoint, enable scanning for the network and select Scan network. ZynoRMM selects the scanner automatically.

Observation, Not Proof

An IP-only device is provisional and can change when DHCP assigns the address again. Open ports and device details are the results of the last observation, not proof of a current open port or a security finding. Discovery inventory ages out over time.

Find managed endpoints on a shared network ​

  1. Open ZynoRMM > Networks and select the discovered network.
  2. Review the Managed endpoints list.
  3. Select an endpoint to open it.

Use Scan network when you need a fresh device observation. The action starts the scan promptly and shows the selected endpoint while it runs. Devices appear as they are found, followed by a completion count or a failure notice. A longer scan does not keep the start request waiting.

Progress belongs to the current connection. Leaving the network page or disconnecting stops progress tracking; it does not cancel an accepted sweep. Return to the network and refresh to see saved observations.

Common issues ​

ProblemWhat To Check
No networks are listedCheck the selected organization and whether a non-deleted managed endpoint has identified the network. Endpoints do not need to be online for inventory to appear.
No eligible scan node is connectedCheck that an included endpoint is online on the network with a physical Ethernet interface, suitable power, and sufficient headroom. An offline endpoint can keep a network visible without being able to scan it.
Scan progress was interruptedReconnect and refresh the network to see observations already saved. Start a new scan if needed.
A network has no active discovery statusThis can be normal while no eligible agent holds the background discovery assignment. Refresh after checking agent connectivity, or request an immediate scan from the selected network.
A device appears with only an IP addressIt could not be given a stable hardware identity. Treat it as provisional.
An expected endpoint is not foundOpen the correct discovered network, then check its Managed endpoints list. The endpoint must be managed and report that same network.

Still need help?

Can’t find what you’re looking for? Our support team is happy to help.